Community
Repair questions & answers
Every question is tagged to a device model and a known problem, so answers stay findable for the next person.
- 18votes6answers
iPhone 14 wakes on charger but side button does nothing — flex or board?
Device was dropped. Screen fine, Face ID fine. Wakes when I plug in, but the side button is completely dead. Should I replace the flex first or measure the board line?
Asked by Hassan K. · 2026-09-06
- 34votes9answers
Bosch PowerTube reads 0 V — is a BMS reset ever safe at home?
Pack sat unused all winter. Charger stays green, output measures 0 V. No swelling. How far should a non-professional go here?
Asked by Ingrid P. · 2026-09-08
- 21votes4answers
MacBook Pro 14 draws 0.00 A at 20 V — where do I start?
Liquid damage suspected. No charge LED. USB-C meter shows negotiation but zero current. Looking for the correct order of measurements.
Asked by Ruben T. · 2026-09-07
- 15votes7answers
PS5 Slim: no video after HDMI swap, retimer suspect?
Replaced the port cleanly, continuity is good on all pins, still blank. Retimer measures warm. What next?
Asked by Kevin O. · 2026-09-04
- 9votes3answers
DJI Mini 3 Pro gimbal overload after flex replacement
New ribbon fitted, calibration completes, but I get gimbal overload after a minute of hover. Slack issue?
Asked by Amira Z. · 2026-09-09
- 42votes12answers
Best thermal camera resolution for hunting shorts on a budget?
Doing more board-level work. Is 256×192 enough, or should I save for something better?
OpenPCB & Electronics#tools#thermal#PCBAsked by Felipe S. · 2026-09-02
Answer questions, build reputation
Helpful answers count toward expert verification and are shown on your public profile.