iPhone 14 display assembly replacement
Replace cracked glass and restore full touch response while preserving True Tone and Face ID.
Safety first — Medium risk
Battery cells and small glass parts. Disconnect power before working and never bend or puncture a cell.
Tools required
- · Pentalobe P2 driver
- · Y000 driver
- · Suction handle
- · Heat pad
- · Spudger
Parts required
- · Display assembly
- · Waterproof adhesive
- · Screw set
Diagnostic notes
Confirm the digitizer is the only fault before ordering parts: a display with dead zones plus flickering can indicate a damaged connector rather than the panel.
Problem mapped: Cracked screen / no touch · component-level severity medium
Repair steps
- 1
Back up and power down
Take a full backup, then shut the device down completely.
Step photo placeholderBack up and power down — illustrative repair step photo placeholder - 2
Warm the adhesive
Heat the edges gently and lift the rear cover, keeping the hinge side intact.
Step photo placeholderWarm the adhesive — illustrative repair step photo placeholder Tip: Low, patient heat beats high heat — overheating warps the frame.
- 3
Disconnect battery and display
Remove brackets and disconnect the battery before the display flexes.
Step photo placeholderDisconnect battery and display — illustrative repair step photo placeholder - 4
Transfer components
Move the earpiece, sensor housing and brackets to the new assembly.
Step photo placeholderTransfer components — illustrative repair step photo placeholder Warning: Damaging the Face ID module is unrecoverable — it cannot be replaced by third parties.
- 5
Seal and test
Fit new adhesive, reassemble, and test touch, brightness, True Tone and Face ID.
Step photo placeholderSeal and test — illustrative repair step photo placeholder
Comments & questions
- No comments yet — be the first to ask something.