iPhone 14 power button flex replacement
Diagnose a dead side button, then replace the power/volume flex without disturbing the Face ID assembly.
Safety first — Medium risk
Battery cells and small glass parts. Disconnect power before working and never bend or puncture a cell.
Tools required
- · Pentalobe P2 driver
- · Tri-point Y000 driver
- · Suction handle
- · Plastic spudger
- · ESD strap
- · Tweezers
Parts required
- · Power/volume flex cable
- · Display adhesive
- · Replacement screws
Diagnostic notes
Before opening: test with an external button trigger through the accessibility menu. If the device wakes on charger connect but not on the side button, the flex is the prime suspect. Measure dome continuity once open — 0 Ω on press confirms a good dome and points at the connector.
Problem mapped: Power button not responding · component-level severity medium
Repair steps
- 1
Power down and discharge
Shut down fully, then discharge the battery below 25% to reduce thermal risk while working near the cell.
Step photo placeholderPower down and discharge — illustrative repair step photo placeholder Warning: Never puncture or bend the battery. A damaged lithium cell can vent and ignite.
- 2
Remove the two pentalobe screws
Remove the bottom-edge P2 screws and keep them on a magnetic mat in position order.
Step photo placeholderRemove the two pentalobe screws — illustrative repair step photo placeholder - 3
Open the rear glass
Apply gentle heat around the perimeter, then lift the rear cover from the bottom edge and swing it open on its hinge side.
Step photo placeholderOpen the rear glass — illustrative repair step photo placeholder Tip: The iPhone 14 opens from the back — do not pry the display like earlier models.
- 4
Disconnect the battery
Remove the battery connector bracket and lift the connector straight up before touching anything else.
Step photo placeholderDisconnect the battery — illustrative repair step photo placeholder - 5
Release the button flex
Unscrew the flex bracket, then walk the connector out with tweezers. Note the cable routing before removal.
Step photo placeholderRelease the button flex — illustrative repair step photo placeholder - 6
Fit the replacement flex
Seat the new flex, confirm the dome sits under the button plunger, and reinstall the bracket screws to light torque.
Step photo placeholderFit the replacement flex — illustrative repair step photo placeholder Tip: Test the button before adhesive goes back in — reopening costs more than a spare minute.
- 7
Reassemble and verify
Reconnect the battery, reseal with fresh adhesive, then verify power, volume, sleep/wake and Face ID.
Step photo placeholderReassemble and verify — illustrative repair step photo placeholder
Comments & questions
- NA
Nadia F.2026-09-01
Step 6 saved me — I tested before adhesive and the dome wasn't seated. Would have redone the whole job.
- TA
Tarek B.2026-09-03
Any torque figure for the flex bracket screws? I'm always nervous about stripping them.
- LA
Layla Haddad2026-09-03
Snug only — these are tiny. If your driver flexes, you've gone too far.